Home › Engine / Hybrid System › 1GD-FTV (ENGINE CONTROL) › MANIFOLD ABSOLUTE PRESSURE SENSOR › from 2021.07
RM35X0E _51 Engine / Hybrid System _078856 1GD-FTV ENGINE CONTROL _0387397 MANIFOLD ABSOLUTE PRESSURE SENSOR G

1GD-FTV ENGINE CONTROL  MANIFOLD ABSOLUTE PRESSURE SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89421C 1.INSPECT DIESEL TURBO PRESSURE SENSOR

a.
A200310C08
1.01,1.708 1.49,1.188 true 2.375,1.75 1.948,1.219 true 0.469,0.313 0.667,0.5 0.198,0.188 10 false *a 0.927,1.76 1.146,2.021 0.219,0.26 10 false E 2.344,1.792 2.563,2.052 0.219,0.26 10 false VC
*a Front view of wire harness connector
(to Diesel Turbo Pressure Sensor)


Inspect the power source voltage.

i.

Disconnect the diesel turbo pressure sensor connector.


ii.

Turn the ignition switch to ON.


iii.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
3 (VC) - 1 (E) Ignition switch ON 4.75 to 5.25 V



iv.

Turn the ignition switch off.


v.

Connect the diesel turbo pressure sensor connector.




b.

Inspect the diesel turbo pressure sensor.

i.

Connect the GTS to the DLC3.


ii.

Turn the ignition switch to ON.


iii.

Turn the GTS on.


iv.

Enter the following menus: Powertrain / Engine / Data List / Atmospheric Pressure and Intake Manifold Absolute Pressure.

Powertrain > Engine > Data List
Tester Display
Atmospheric Pressure
Intake Manifold Absolute Pressure
50003 372 229,385

v.

Disconnect the vacuum hose from the diesel turbo pressure sensor.


vi.

Using SST, apply pressure to the diesel turbo pressure sensor.

SST
09992-00242  

A454031C01
2.594,0.979 2.667,0.583 2.667,0.583 2.833,0.583 false 2.385,2.563 2.5,2.25 2.5,2.25 2.667,2.25 false 6.302,0.885 6.417,0.427 6.417,0.427 6.583,0.427 false 6.073,2.479 6.167,2.167 6.167,2.167 6.417,2.167 false 0.083,0.083 0.396,0.281 0.313,0.198 10 false *A 3.833,0.083 4.146,0.281 0.313,0.198 10 false *B 2.917,0.5 3.375,0.698 0.458,0.198 10 false SST 2.75,2.167 3.063,2.365 0.313,0.198 10 false *a 6.667,0.333 7.083,0.5 0.417,0.167 10 false SST 6.5,2.083 6.813,2.281 0.313,0.198 10 false *a
*A for Air Cooled Type Intercooler *B for Water Cooled Type Intercooler
*a Vacuum Pump - -



vii.

Using a vacuum pump, apply vacuum to the diesel turbo pressure sensor.


viii.

Read the value.

OK:
Condition MAP Value
No pressure applied Same as atmospheric pressure
Pressure applied Indicates pressure
Vacuum applied Indicates vacuum


If the result is not as specified, replace the diesel turbo pressure sensor or ECM.