INSPECTION
Inspection · Vehicles built from May 2007
| INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
Jack up the vehicle.
Disconnect the park/neutral position switch connector.

Measure the resistance according to the value(s) in the table below when the shift lever is moved to each position.
- Standard resistance:
Tester Connection
Shift Position
Specified Condition
4 - 5
P and N
Below 1 Ω
Except P and N
10 kΩ or higher
2 - 6
P
Below 1 Ω
Except P
10 kΩ or higher
2 - 1
R
Below 1 Ω
Except R
10 kΩ or higher
2 - 9
N
Below 1 Ω
Except N
10 kΩ or higher
2 - 7
D, S, "+" and "-"
Below 1 Ω
Except D, S, "+" and "-"
10 kΩ or higher
