ADJUSTMENT
Removal / installation · Vehicles built from May 2007
| 1. INSPECT AND ADJUST DIFFERENTIAL OIL |
Stop the vehicle on a level place.
Remove the differential filler plug and gasket.
Check that the oil surface is within 5 mm (0.20 in.) of the lowest position of the inner surface of the differential filler plug opening.

- NOTICE:
- Excessively large or small amounts of oil may cause trouble.
- After replacing oil, drive the vehicle and check the oil level.
- Excessively large or small amounts of oil may cause trouble.
- HINT:
- If necessary, fill the rear differential carrier with hypoid gear oil.
- Oil grade:
- Hypoid gear oil API GL-5
- Recommended oil viscosity:
- Above -18°C (0°F) : SAE 90
Below -18°C (0°F) : SAE 80W or 80W-90
- Capacity:
- 0.9 +/- 0.05 liters (0.95 +/- 0.05 US qts, 0.79 +/- 0.04 lmp. qts)
Check for oil leakage when the oil level is low.
Install the differential filler plug and a new gasket.
- Torque:
- 49 N*m{ 500 kgf*cm , 36 ft.*lbf }
