Noise Occurs
Circuit diagnosis · Vehicles built May 2007 – Jul 2008
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
INSPECTION PROCEDURE
| 1. NOISE CONDITION |
Check from which direction the noise comes (front left or right, or rear left or right).
Check from which direction the noise comes.
- OK:
- The location of the noise source can be determined.
|
|
||||
| OK | |
| 2. CHECK SPEAKERS |
Check the installation conditions of the speaker units that are located near the noise source and that there are no cracks, scratches, deformation, or other failures.
- Result:
Condition
Proceed to
A speaker is installed incorrectly
A
Foreign objects are in the speaker
B
A speaker cone paper is broken
C
No malfunction is found
D
|
|
||||
|
|
||||
|
|
||||
| D | |
| 3. CHECK NOISE CONDITIONS |
Check the noise condition.
- HINT:
- The radio has a noise prevention function to reduce noise when listening to the radio. If a loud noise occurs, check whether the ground at the antenna mounting base and the noise prevention unit are installed and wired correctly.
Conditions under which noise occurs
Noise source
Noise increases when the accelerator pedal is depressed, but stops when the engine is stopped.
Generator
Noise occurs during A/C or heater operation.
Blower motor
Noise occurs when the horn switch is pressed and released or when pressed and held.
Horn
Noise occurs synchronously with the blink of the turn signal.
Flasher
Noise occurs during window washer operation.
Washer
Noise occurs during wiper operation.
Wiper
Noise occurs when the brake pedal is depressed.
Stop light switch
Others
Static electricity
- HINT:
- In the chart's left column, find the situation that matches the customer's complaint. Then, in the right column, find the part that is causing the noise. Check the respective noise filter.
- To save time and avoid a misdiagnosis, first make sure that the noise is not coming from outside the vehicle.
- Troubleshoot noises in descending order of loudness.
- Setting the radio to a frequency where no signal is received may make recognition of the noise problem easier.
- In the chart's left column, find the situation that matches the customer's complaint. Then, in the right column, find the part that is causing the noise. Check the respective noise filter.
- OK:
- The noise source cannot be determined.
|
|
||||
| OK | ||
| ||
