If the voltage is below 11 V, recharge or replace the battery before proceeding.
NEXT
3.BASIC INSPECTION
Turn the ignition switch on (IG).
Check whether or not the radio receiver turns on.
Result:
Result
Proceed to
Radio receiver turns on
A
Radio receiver does not turn on
B
B.
A
4.CHECK FOR DTC
Check for DTCs and note any codes that are output.
Delete the DTCs.
Recheck for DTCs by simulating the operation indicated by the DTCs.
HINT:
If the system cannot enter the diagnostic mode, inspect the AVC-LAN and all the components that connect to the AVC-LAN for short circuits and repair or replace the problem part.
Even if the malfunction symptom is not confirmed, check the DTCs. This is because the system stores past DTCs.
Check and clear past DTCs. Then check for DTCs.
Result:
Result
Proceed to
DTC is output again
A
DTC is not output
B
B.
A
5.DIAGNOSTIC TROUBLE CODE CHART
Find the output code in the diagnostic trouble code chart (Click here).