2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

Illumination for Panel Switch does not Come on with Tail Switch ON

Circuit diagnosis · Vehicles built Jul 2010 – Jun 2012

Versions by build date: Jul 2010 – Jun 2012 from Jul 2012

INSPECTION PROCEDURE


1. CHECK VEHICLE SIGNAL (OPERATION CHECK)
E176538
  1. Enter the "Vehicle Signal Check Mode" screen. Refer to Check Vehicle Signal in Operation Check (Click here).

  1. Check that the display changes between ON and OFF according to the light control switch operation.

    OK:
    Light Control Switch
    Display
    Tail or on
    ON
    Off
    OFF

    HINT:
    This display is updated once per second. As a result, it is normal for the display to lag behind the actual switch operation.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)


← Radio Broadcast cannot be Received or Poor Reception (from Jul 2010)Illumination for Panel Switch does not Come on with Tail Switch ON (from Jul 2012) →