Display does not Dim when Light Control Switch is Turned ON
Circuit diagnosis · Vehicles built Jul 2010 – Jun 2012
Versions by build date: Jul 2010 – Jun 2012 from Jul 2012
INSPECTION PROCEDURE
| 1. CHECK IMAGE QUALITY SETTING |
 |
- Enter the display adjustment screen by pressing the "DISP" switch.
Turn the light control switch to the tail position.
Check if "Day Mode" on the display adjustment screen is on.
- Result:
Result
|
Proceed to
|
"Day Mode" is on
|
A
|
"Day Mode" is off
|
B
|
Text in Illustration
*a
|
Example
|
|
B |
 |
|
|
|
| A |
|
 |
|
| TURN "Day Mode" SETTING OFF |
|
| 2. CHECK VEHICLE SIGNAL (OPERATION CHECK) |
 |
- Enter the "Vehicle Signal Check Mode" screen. Refer to Check Vehicle Signal in Operation Check (Click here).
Check that the display changes between ON and OFF according to the light control switch operation.
- OK:
Light Control Switch
|
Display
|
Tail or on
|
ON
|
Off
|
OFF
|
- HINT:
- The display is updated once per second. It is normal for the display to lag behind the actual switch operation.
|
NG |
 |
|
| PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
|
|
|
| OK |
|
 |
|
|