Circuit diagnosis · Vehicles built Jul 2010 – Jun 2012
Versions by build date: Jul 2010 – Jun 2012from Jul 2012
INSPECTION PROCEDURE
1. CHECK MULTI-DISPLAY
Check if there is any foreign matter caught between the display and exterior frame of the multi-display.
OK:
No foreign matter is caught between the display and exterior frame of the multi-display.
HINT:
If there is foreign matter between the display and exterior frame of the multi-display, the touch panel will remain pressed, preventing touch switch operation.
NG
REMOVE FOREIGN MATTER
OK
2. CHECK TOUCH PANEL
Check for foreign matter on the display.
OK:
The display is clean.
NG
CLEAN DISPLAY AND RECHECK TOUCH PANEL
OK
3. CHECK TOUCH SWITCH (OPERATION CHECK)
Enter the "Touch Switch Check" screen. Refer to Check Touch Switch in Operation Check (Click here).
Touch the display in the area where the switch malfunction occurs.
OK:
A "+" mark appears at the touched position.
NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)