Route cannot be Calculated
Circuit diagnosis · Vehicles built Jul 2010 – Jun 2012
Versions by build date: Jul 2010 – Jun 2012 from Jul 2012
INSPECTION PROCEDURE
| 1. CHECK HARD DISK DRIVE (OPERATION CHECK) |
 |
- Enter the "Failure Diagnosis" screen. Refer to Check Hard Disk Drive in Operation Check (Click here).
Select "HDD Check" and check the result.
- OK:
- "OK" is displayed.
- HINT:
- After "HDD Check" is selected, it may take a while until the result is displayed.
Text in Illustration
*a
|
Result
|
|
NG |
 |
|
|
|
| OK |
|
 |
|
| 2. CHECK CABIN |
 |
Check that condensation is not likely to occur in the cabin, and that the temperature is not high or extremely low in the cabin.
- HINT:
- A humid cabin and a rapid change in temperature may lead to condensation. Condensation in the cabin may cause a short circuit.
- The navigation system may not operate normally when the temperature is -20°C (-4°F) or lower, or 65°C (149°F) or higher.
- OK:
- Condensation is not likely being produced and the temperature is not high or extremely low.
|
NG |
 |
|
| SET CABIN TO APPROPRIATE TEMPERATURE |
|
|
| OK |
|
 |
|
| 3. SET DESTINATION |
 |
Set another destination and check if the system can calculate the route correctly.
- OK:
- Route can be correctly calculated.
|
NG |
 |
|
| PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
|
|
|
| OK |
|
 |
|
|