2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

Voice is not Recognized

Circuit diagnosis · Vehicles built Jul 2010 – Jun 2012

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 Jul 2010 – Jun 2012 from Jul 2012

INSPECTION PROCEDURE


1. CHECK NAVIGATION SETTING
  1. Enter the "Setup" screen.

  1. E190575E04
    Check that "Voice Recognition Guidance" is not "OFF".

    OK:
    "Voice Recognition Guidance" is not "OFF".

    Text in Illustration 
    *a
    Example



NG
TURN VOICE RECOGNITION GUIDANCE "ON"
OK


2. CHECK MAP DISC

  1. I100152E12
    Check that the map disc is not deformed or cracked.

    OK:
    No deformations or cracks on the map disc



NG
REPLACE MAP DISC
OK


3. CHECK MAP DISC

  1. I100201E04
    Check for dirt on the map disc surface.

    OK:
    No dirt is on the map disc surface.

    NOTICE:
    Do not use a conventional record cleaner or anti-static preservative.

    HINT:
    If the map disc is dirty, clean the map disc by wiping the map disc surface radially with a soft cloth.



NG
CLEAN MAP DISC
OK


4. CHECK MICROPHONE (OPERATION CHECK)

  1. E176524E16
    Enter the "Microphone&Voice Recognition Check" screen (Check Mic & Voice Recognition) (Click here).

  1. When voice is input into the microphone, check that the microphone input level meter changes according to the input voice.

  1. Push the recording switch and perform voice recording.

    HINT:
    1. Voice can be recorded up to 5 seconds.
    2. Select the recording switch with the blower motor of the air conditioning system stopped. If an outlet of the air conditioning system is facing the microphone, noise may be recorded.

  1. Check that the recording indicator remains on while recording and that the recorded voice is played normally without noise or distortion.

    OK:
    All check results are normal.

    Text in Illustration 
    *a
    Microphone Input Level Meter
    *b
    Recording Switch
    *c
    Stop Switch
    *d
    Play Switch
    *e
    Recording Indicator



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)


← Voice is not Recognized (Aug 2008 – Jun 2010)Voice is not Recognized (from Jul 2012) →