2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

Cursor or Map Rotates when Vehicle Stopped

Circuit diagnosis · Vehicles built from Jul 2010

INSPECTION PROCEDURE


1. CHECK CONDITION

  1. E106418
    Check with the customer if the vehicle has been turned by a turntable.

    OK:
    Vehicle has not been turned by a turntable.

    HINT:
    If the vehicle is turned on a turntable with the ignition switch ON, the system may store the angular velocity. As a result, the vehicle position cursor may deviate. In this case, the vehicle position cursor will return to normal by turning the ignition switch off and back to ON again with the vehicle completely stopped.



NG
TURN IGNITION SWITCH TO ON WHEN VEHICLE IS COMPLETELY STOPPED
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Vehicle Position Mark Deviates Greatly (from Jul 2012)Vehicle Position Mark is not Updated (Jul 2010 – Jun 2012) →