2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

Current Position Display does not Appear

Circuit diagnosis · Vehicles built Jul 2010 – Jun 2012

Versions by build date: Jul 2010 – Jun 2012 from Jul 2012

INSPECTION PROCEDURE


1. CHECK HARD DISK DRIVE (OPERATION CHECK)

  1. E181026E11
    Enter the "Failure Diagnosis" screen. Refer to Check Hard Disk Drive in Operation Check (Click here).

  1. Select "HDD Check" and check the result.

    OK:
    "OK" is displayed.

    HINT:
    After "HDD Check" is selected, it may take a while until the result is displayed.

Text in Illustration 
*a
Result


NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK


2. CHECK CABIN
  1. Check that condensation is not likely to occur in the cabin, and that the temperature is not high or extremely low in the cabin.

    HINT:
    1. A humid cabin and a rapid change in temperature may lead to condensation. Condensation in the cabin may cause a short circuit.
    2. The navigation system may not operate normally when the temperature is -20°C (-4°F) or lower, or 65°C (149°F) or higher.

    OK:
    Condensation is not likely being produced and the temperature is not high or extremely low.



NG
SET CABIN TO APPROPRIATE TEMPERATURE
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Vehicle Position Mark is not Updated (from Jul 2012)Current Position Display does not Appear (from Jul 2012) →