2007-2013 Highlander Kluger · Service Manual SECURITIES

DATA LIST / ACTIVE TEST

System information · Vehicles built from May 2007


READ DATA LIST

HINT:
Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the engine switch on (IG).

  3. Turn the tester on.

  4. Read the Data List according to the display on the tester.

Smart Key (Certification ECU (Smart Key ECU Assembly)): 
Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Ignition Switch
Engine switch on (IG) signal / ON or OFF
ON: Engine switch on (ACC, IG) or engine started
OFF: Engine switch off
-
ACC Switch
Engine switch on (ACC) signal / ON or OFF
ON: Engine switch on (ACC, IG) or engine started
OFF: Engine switch off
-
Immobiliser
Immobiliser system status / SET or UNSET
SET: Key is not in cabin
UNSET: Key is in cabin
-
Master Key
Master key code signal / MATCH or NO MATCH
MATCH: Master key code is sent
NO MATCH: Unmatched master key code is sent
-
Sub Key
Sub-key (Master key) code signal / MATCH or NO MATCH
MATCH: Sub-key (master key) code is sent
NO MATCH: Unmatched sub-key (master key) code is sent
-
BCC Malfunction
Transponder chip signal / OK or NG
OK: Correct data sent
NG: Incorrect data sent
-
Abnormal Status
Transponder chip data / OK or NG
OK: Data OK
NG: Data error
-
Different Encrypt Code
Transponder chip signal / OK or NG
OK: Correct data sent
NG: Incorrect data sent
-
Different Serial Number
Transponder chip signal / OK or NG
OK: Correct data sent
NG: Incorrect data sent
-
Frame Error
Transponder chip signal / OK or NG
OK: Correct data sent
NG: Incorrect data sent
-
Response
Transponder chip signal / OK or NG
OK: Correct data sent
NG: Incorrect data sent
-

PERFORM ACTIVE TEST

HINT:
Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the engine switch on (IG).

  3. Turn the tester on.

  4. Perform the Active Test by following the directions on the tester screen.

Smart Key (Certification ECU (Smart Key ECU Assembly)): 
Tester Display
Test Part
Control Range
Diagnostic Note
Security Indic
Security indicator light
ON/OFF
-
← DTC CHECK / CLEAR (from May 2007)DIAGNOSTIC TROUBLE CODE CHART (May 2007 – Jul 2008) →