2007-2013 Highlander Kluger · Service Manual SECURITIES

B2784 Antenna Coil Open / Short

Diagnostic trouble codes · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

This DTC is output when there is an open or short in the key coil (built into the engine switch).
DTC No.
DTC Detection Condition
Trouble Area
B2784
Antenna coil is open/shorted
  1. Wire harness or connector
  2. Certification ECU (Smart key ECU assembly)
  3. Engine switch

WIRING DIAGRAM

B151004E04

INSPECTION PROCEDURE

NOTICE:
If the certification ECU (smart key ECU assembly) is replaced, register the key and ECU communication ID.


1. CHECK DTC OUTPUT
  1. Delete the DTCs (Click here).

  1. Recheck for DTCs.

    OK:
    B2784 output does not recur.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)

2. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - ENGINE SWITCH)

  1. B178824E01
    Disconnect the certification ECU (smart key ECU assembly) and engine switch connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D36-9 (CODE) - D22-10 (CODE)
    Always
    Below 1 Ω
    D36-8 (TXCT) - D22-9 (TXCT)
    Always
    Below 1 Ω
    D36-9 (CODE) - Body ground
    Always
    10 kΩ or higher
    D36-8 (TXCT) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. REPLACE ENGINE SWITCH
  1. Replace the engine switch (Click here).


NEXT


4. CHECK DTC OUTPUT
  1. Delete the DTCs (Click here).

  1. Recheck for DTCs.

    OK:
    B2784 output does not recur.



NG
REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
OK

END (ENGINE SWITCH IS DEFECTIVE)


← B2784 Antenna Coil Open / Short (May 2007 – Jul 2008)B2784 Antenna Coil Open / Short (from Jul 2010) →