2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

CUSTOMIZE PARAMETERS

Troubleshooting · Vehicles built from May 2007

HINT:
The following items can be customized.

NOTICE:
  1. Before attempting to customize vehicle settings, confirm whether it is possible to make the change that the customer has requested.
  2. Be sure to record the current value before customizing.
  3. Before troubleshooting the lighting system, pay attention because there is a possibility that a function has been disabled by customizing. (Example: If "The wireless operation does not function", check that the wireless operation has not been disabled by customizing, then perform the troubleshooting.)

Illuminated Entry: 
Display
Default
Contents
Setting
Lighting Time
15 s
Changes the lighting time of the personal light, interior lights and ignition key cylinder light*1/engine switch illumination*2 after closing all of the doors. (It will quickly fade out when the ignition switch is turned on (IG))
7.5 s / 15 s / 30 s
I/L when ACC OFF
ON
Lights up the personal light, interior lights and ignition key cylinder light*1/engine switch illumination*2 when the ignition switch is turned from on (ACC or IG) to off.
ON / OFF
I/L ON W/Door Key Unlock
ON
Lights up the personal light, interior lights and ignition key cylinder light*1/engine switch illumination*2 when the doors are unlocked using the mechanical key.
ON / OFF
Mirr-Foot-Lgt Approached
ON
Lights up the door mirror foot lights when the key enters actuation area around the doors.
ON / OFF
Mirr-Foot-Lgt Unlocked
ON
Lights up the door mirror foot lights when the doors are unlocked using door control transmitter or mechanical key.
ON / OFF
Mirr-Foot-Lgt w/Master SW
ON
Lights up the door mirror foot lights when the doors are unlocked with the door control switch.
ON / OFF
Mirror Foot Light Time
15 s
Changes the lighting time of the door mirror foot lights.
0 s / 7.5 s / 15 s / 30 s

HINT:
  1. *1: w/o Smart Entry and Start System
  2. *2: w/ Smart Entry and Start System

Light Control: 
Display
Default
Contents
Setting
Response Time
Normal
Changes the delay timing of lighting the taillight when going into a tunnel when the light control switch is in the AUTO position.
Long / Normal
Sensitivity
Normal
Adjusts the sensitivity of the automatic light control function.
Light2 / Light1 / Normal / Dark1 / Dark2
Disp Ex ON Sen
Normal
Changes the ambient brightness level required to dim the lights such as the indicator lights of the combination meter, A/C indicator light, and clock.
Light2 / Light1 / Normal / Dark1 / Dark2
Disp Ex OFF Sen
Normal
Changes the ambient brightness level required to cancel the dimming of the combination meter indicator lights, A/C indicator light, and clock.
Light2 / Light1 / Normal / Dark1 / Dark2
← HOW TO PROCEED WITH TROUBLESHOOTING (from May 2007)PROBLEM SYMPTOMS TABLE (May 2007 – Jul 2008) →