2007-2013 Highlander Kluger · Service Manual RESTRAINTS

REMOVAL

Removal / installation · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


1. PRECAUTION

CAUTION:
Be sure to read "PRECAUTION" thoroughly before servicing (Click here).


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for at least 90 seconds after disconnecting the cable to prevent airbag deployment.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


3. REMOVE LOWER NO. 3 STEERING WHEEL COVER

  1. C165090
    Disengage the claw and remove the lower No. 3 steering wheel cover.


4. REMOVE LOWER NO. 2 STEERING WHEEL COVER

  1. C165091
    Disengage the claw and remove the lower No. 2 steering wheel cover.


5. REMOVE STEERING PAD

  1. C166981E01
    Using a "TORX" socket wrench (T30), loosen the 2 "TORX" screws until the groove along the screw circumference catches on the screw case.

  1. C165092
    Pull out the steering pad from the steering wheel assembly and support the steering pad with one hand as shown in the illustration.

    NOTICE:
    When removing the steering pad, do not pull the airbag wire harness.

  1. C165094E01
    Disconnect the horn connector from the steering pad.

  1. Using a screwdriver with the tip wrapped with protective tape, disconnect the 2 airbag connectors and remove the steering pad.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

← ON-VEHICLE INSPECTION (from Jul 2010)REMOVAL (Aug 2008 – Jun 2010) →