TERMINALS OF ECU
System information · Vehicles built from May 2007
| CHECK SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (SLIDING ROOF CONTROL ECU) |


Disconnect the Q12 ECU connector.
Measure the resistance and voltage according to the value(s) in the table below.
If the result is not as specified, there may be a malfunction on the wire harness side.Terminal No. (Symbols)
Wiring Color
Terminal Description
Condition
Specified Condition
Q12-1(B) - Q12-2 (E)
B - W-B
+B power supply
Always
10 to 14 V
Q12-5 (IG) - Q12-2 (E)
Y - W-B
Ignition switch power supply
Ignition switch off
Below 1 V
Q12-5 (IG) - Q12-2 (E)
Y - W-B
Ignition switch power supply
Ignition switch on (IG)
10 to 14 V
Q12-7 (OPN) - Q12-2 (E)
V - W-B
Sliding roof motor open
OPEN switch OFF
10 kΩ or higher
Q12-7 (OPN) - Q12-2 (E)
V - W-B
Sliding roof motor open
OPEN switch ON
Below 1 Ω
Q12-9 (CLS) - Q12-2 (E)
W - W-B
Sliding roof motor closed
CLOSE switch OFF
10 kΩ or higher
Q12-9 (CLS) - Q12-2 (E)
W - W-B
Sliding roof motor closed
CLOSE switch ON
Below 1 Ω
Q12-10 (UP) - Q12-2 (E)
BR - W-B
Sliding roof motor up
UP switch OFF
10 kΩ or higher
Q12-10 (UP) - Q12-2 (E)
BR - W-B
Sliding roof motor up
UP switch ON
Below 1 Ω
Q12-8 (DWN) - Q12-2 (E)
P - W-B
Sliding roof motor down
DOWN switch OFF
10 kΩ or higher
Q12-8 (DWN) - Q12-2 (E)
P - W-B
Sliding roof motor down
DOWN switch ON
Below 1 Ω
Q12-2 (E) - Body ground
W-B - Body ground
Ground
Always
Below 1 Ω
Reconnect the Q12 ECU connector.
Measure the voltage according to the value(s) in the table below.
If the result is not as specified, the ECU may have a malfunction.Symbols (Terminal No.)
Wiring Color
Terminal Description
Condition
Specified Condition
Q12-7 (OPN) - Q12-2 (E)
V - W-B
Sliding roof motor open
Ignition switch on (IG), sliding roof closed, OPEN switch OFF
Below 1 V
Q12-7 (OPN) - Q12-2 (E)
V - W-B
Sliding roof motor open
Ignition switch on (IG), sliding roof closed, OPEN switch ON
10 to 14 V
Q12-9 (CLS) - Q12-2 (E)
W - W-B
Sliding roof motor closed
Ignition switch on (IG), sliding roof open, CLOSE switch OFF
Below 1 V
Q12-9 (CLS) - Q12-2 (E)
W - W-B
Sliding roof motor closed
Ignition switch on (IG), sliding roof open, CLOSE switch ON
10 to 14 V
Q12-10 (UP) - Q12-2 (E)
BR - W-B
Sliding roof motor up
Ignition switch on (IG), sliding roof tilted downward, UP switch OFF
Below 1 V
Q12-10 (UP) - Q12-2 (E)
BR - W-B
Sliding roof motor up
Ignition switch on (IG), sliding roof tilted downward, UP switch ON
10 to 14 V
Q12-8 (DWN) - Q12-2 (E)
P - W-B
Sliding roof motor down
Ignition switch on (IG), sliding roof tilted upward, DOWN switch OFF
Below 1 V
Q12-8 (DWN) - Q12-2 (E)
P - W-B
Sliding roof motor down
Ignition switch on (IG), sliding roof tilted upward, DOWN switch ON
10 to 14 V