2007-2013 Highlander Kluger · Service Manual RESTRAINTS

ON-VEHICLE INSPECTION

Inspection · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


INSPECT SIDE AIRBAG SENSOR (VEHICLE NOT INVOLVED IN COLLISION)
  1. Perform a diagnostic system check (Click here).


INSPECT SIDE AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED)
  1. Perform a diagnostic system check (Click here).

  1. If the center pillar of the vehicle or the area around it is damaged, check if there is any damage to the side airbag sensor. If there are any defects as mentioned below, replace the side airbag sensor with a new one:

    1. Cracks, dents or chips on the sensor housing.
    2. Cracks or other damage to the connector.
    3. Peeling off of the label or damage to the serial number.

    CAUTION:
    For removal and installation of the side airbag sensor, be sure to follow the correct procedures.


INSPECT SIDE AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG IS DEPLOYED)
  1. When airbags have deployed as the result of a collision, be certain to replace all side airbag sensors in the damaged area (anywhere in need of repair). Furthermore, it is also necessary to replace any side airbag sensors in undamaged areas that have registered a major collision, or which exhibit any of the following abnormalities.

    1. Cracks, dents or chips on the sensor housing.
    2. Cracks or other damage to the connector.
    3. Peeling off of the label or damage to the serial number.

    CAUTION:
    For removal and installation of the side airbag sensor, be sure to follow the correct procedures.

← ON-VEHICLE INSPECTION (May 2007 – Jul 2008)ON-VEHICLE INSPECTION (from Jul 2010) →