2007-2013 Highlander Kluger · Service Manual TRANSMISSION

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

HINT:
  1. The ECM of this system is connected to the CAN and multiplex communication system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN and multiplex communication systems.
  2. *: Use Intelligent tester


1.Vehicle Brought to Workshop
    NEXT

    2.Customer Problem Analysis
      NEXT

      3.Inspect Battery Voltage

        Standard voltage:
        11 to 14 V

        If the voltage is below 11 V, recharge or replace the battery before proceeding.
      NEXT

      4.Connect Intelligent tester to the DLC3*
        NEXT

        5.Check and Clear DTCs and Freeze Frame Data*

          HINT:
          (Click here).

        NEXT

        6.Visual Inspection
          NEXT

          7.Setting the Check Mode Diagnosis*

            HINT:
            (Click here).

          NEXT

          8.Problem Symptom Confirmation

            HINT:
            (Click here).

            Result:
            Result
            Proceed to
            Symptom does not occur
            A
            Symptom occurs
            B


          B.
          A

          9.Symptom Simulation

            HINT:
            (Click here).

          NEXT

          10.DTC Check*

            HINT:
            (Click here).

            Result:
            Result
            Proceed to
            DTC is not output
            A
            DTC is output
            B


          B.
          A

          11.Basic Inspection

            HINT:
            (Click here, Click here and Click here).


          NG.
          OK

          12.Mechanical System Test

            HINT:
            (Click here).


          NG.
          OK

          13.Hydraulic Test

            HINT:
            (Click here).


          NG.
          OK

          14.Manual Shifting Test

            HINT:
            (Click here).


          NG.
          OK

          15.Problem Symptoms Table Chapter 1

            HINT:
            (Click here).


          NG.
          OK

          16.Problem Symptoms Table Chapter 2

            HINT:
            (Click here).

          NEXT

          17.Part Inspection
            NEXT

            18.DTC Chart

              HINT:
              (Click here).

            NEXT

            19.Circuit Inspection
              NEXT

              20.Identification of Problem
                NEXT

                21.Repair or Replace
                  NEXT

                  22.Confirmation Test
                    NEXT

                    ← HOW TO PROCEED WITH TROUBLESHOOTING (Aug 2008 – Jun 2010)ROAD TEST (from May 2007) →