2007-2013 Highlander Kluger · Service Manual STEERING

PRECAUTION

Precautions · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


1.IGNITION SWITCH EXPRESSIONS

HINT:
The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.
Expression
Switch Type
Ignition Switch (position)
Engine Switch (condition)
Ignition Switch off
LOCK
Off
Ignition Switch on (IG)
ON
On (IG)
Ignition Switch on (ACC)
ACC
On (ACC)
Engine Start
START
Start


2.HANDLING PRECAUTIONS FOR STEERING SYSTEM
  1. Care must be taken when replacing parts. Incorrect replacement may affect the performance of the steering system and result in driving hazards.


3.HANDLING PRECAUTIONS FOR SRS AIRBAG SYSTEM
  1. The vehicle is equipped with SRS (Supplemental Restraint System). Failure to carry out service operations in the correct sequence could cause the SRS to unexpectedly deploy during servicing. This may cause a serious accident. Before servicing (including inspection, replacement, removal, and installation of parts), be sure to read the precautionary notices for the Supplemental Restraint System (Click here).


4.HANDLING PRECAUTIONS FOR STEERING COLUMN
  1. When handling the steering column assembly:

    1. Avoid any impact to the steering column assembly, especially to the motor or the torque sensor. Replace the steering column assembly with a new one if it is dropped or subjected to any severe impacts.

    2. Do not pull the wire harness when moving the steering column assembly.

    3. Do not release the tilt lever when the steering column assembly is not installed on the vehicle.

  2. When disconnecting or reconnecting the connectors:

    1. When disconnecting the connectors related to the electronic motor power steering system, turn the ignition switch on (IG) (the engine is stopped), center the steering wheel, turn the ignition switch off, and then disconnect the connectors.

    2. When reconnecting the connectors related to the electronic motor power steering system, make sure that the ignition switch is turned off, center the steering wheel and then turn the ignition switch on (IG) (the engine is stopped).

      NOTICE:
      Do not turn the ignition switch on (IG) without the steering wheel being centered.

← PRECAUTION (Aug 2008 – Jun 2010)PROBLEM SYMPTOMS TABLE (May 2007 – Jul 2008) →