2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

CUSTOMIZE PARAMETERS

Troubleshooting · Vehicles built May 2007 – Jun 2010

Versions by build date: May 2007 – Jun 2010 from Jul 2010


CUSTOMIZING FUNCTION WITH INTELLIGENT TESTER

HINT:
The following items can be customized.

NOTICE:
  1. When the customer requests a change in a function, first make sure that the function can be customized.
  2. Be sure to make a note of the current settings before customizing.
  3. When troubleshooting a function, first make sure that the function is set to the default setting.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch on (IG).

  3. Turn the tester on.

  4. Select the setting by referring to the table below.

    Main Body (Main Body ECU): 
    Display
    Default
    Contents
    Setting
    Unlock Key Twice (*2)
    ON
    Function that unlocks only driver side door when driver side door key cylinder is turned to UNLOCK once, and unlock all doors when it is turned to UNLOCK twice. For OFF setting, turning it once unlocks all doors.
    ON/OFF
    Auto Lock/Shift (*1)
    ON
    Function that locks all doors when shift lever is shifted to P from any other position with engine running and all doors closed
    ON/OFF
    Auto Unlock/Shift (*1)
    ON
    Function that unlocks all doors when shift lever is shifted to P from any other position while the ignition switch is on (IG)
    ON/OFF
    All Unlock/Open-Close (*1)
    OFF
    Function that unlocks all doors when opening driver door within 10 seconds after turning the ignition switch on (IG)
    ON/OFF
    Auto Lock (*1)
    OFF
    Function that locks all doors when the vehicle reaches a certain speed
    ON/OFF

    HINT:
    1. *1: for LHD
    2. *2: for RHD

← OPERATION CHECK (from Jul 2010)CUSTOMIZE PARAMETERS (from Jul 2010) →