2007-2013 Highlander Kluger · Service Manual COMMUNICATION SYSTEM

PRECAUTION

Precautions · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


1.IGNITION SWITCH EXPRESSIONS

HINT:
The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.
Expression
Ignition Switch (position)
Engine Switch (condition)
Ignition Switch off
LOCK
Off
Ignition Switch on (IG)
ON
On (IG)
Ignition Switch on (ACC)
ACC
On (ACC)
Engine Start
START
Start


2.STEERING SYSTEM HANDLING PRECAUTIONS
  1. Care must be taken when replacing parts. Incorrect replacement could affect the performance of the steering system and result in hazardous driving.


3. SRS AIRBAG SYSTEM HANDLING PRECAUTIONS
  1. This vehicle is equipped with an SRS (Supplemental Restraint System) which includes parts such as the driver airbag and front passenger airbag. Failure to carry out service operations in the correct sequence could cause unexpected SRS deployment during servicing and may lead to a serious accident. Before servicing (including removal or installation of parts, inspection or replacement), be sure to read the precautionary notice for the SRS (Click here).


4.BUS WIRE REPAIR

  1. F045104
    After repairing a bus wire with solder, wrap the repaired part with electrical tape.

    NOTICE:
    1. The CANL bus wire and CANH bus wire must be installed together at all times.
    2. When installing, make sure that they are twisted.
    3. CAN bus wires are likely to be influenced by electrical noise if the bus wires are not twisted.
    4. The difference in length between the CANL bus wire and CANH bus wire should be 100 mm (3.937 in.) or less.
    5. Leave approximately 80 mm (3.150 in.) loose in the twisted wires around the connector.

  2. F045105E14
    Do not use bypass wiring between the connectors.

    NOTICE:
    The ability of the twisted bus wires to resist interference will be lost if bypass wiring is used.


5.CONNECTOR HANDLING

  1. F045106E01
    When checking resistance with a tester, insert the tester probes from the backside (harness side) of the connector.

  2. F045107E13
    Use service wires to check the connector if it is impossible to check continuity from the rear of the connector.


6.PRECAUTIONS FOR INSPECTING OR REPLACING CAN JUNCTION CONNECTOR
  1. If the CAN junction connector is removed from the vehicle for inspection or replacement, make sure to install the CAN junction connector and all wire harnesses to their original locations with tape and the clamps.

← PRECAUTION (May 2007 – Jul 2008)PRECAUTION (from Jul 2010) →