2007-2013 Highlander Kluger · Service Manual COMMUNICATION SYSTEM

ECM Communication Stop Mode

Circuit diagnosis · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

Detection Item
Symptom
Trouble Area
ECM Communication Stop Mode
  1. "Engine" is not displayed on "Communication Bus Check" screen of intelligent tester
  2. Applies to "ECM Communication Stop Mode" in "DTC COMBINATION TABLE"
  1. Power source circuit of ECM
  2. ECM

WIRING DIAGRAM

C169663E02
C170365E01

INSPECTION PROCEDURE

NOTICE:
  1. Turn the ignition switch off before measuring the resistances of CAN bus main wires and CAN bus branch wires.
  2. After the ignition switch is turned off, check that the key reminder warning system and light reminder warning system are not operating.
  3. Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches, or the doors. If any doors need to be opened in order to check the connectors, open the doors and leave them open.

HINT:
  1. Operating the ignition switch, any other switches, or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.
  2. Even after DTCs are cleared, if a DTC is stored again after driving the vehicle for a while, the malfunction may be occurring due to vibration of the vehicle. In such a case, wiggling the ECUs or wire harness while performing the inspection below will help determine the cause of the malfunction.


1. CHECK FOR OPEN IN CAN NO. 1 BUS MAIN WIRE (ECM MAIN WIRE)
  1. Turn the ignition switch off.

  1. Disconnect the ECM connector.

  1. C170023E04
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D32-33 (CANH) - D32-34 (CANL)
    Ignition switch off
    108 to 132 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. CHECK WIRE HARNESS (POWER SOURCE CIRCUIT)
  1. Check the ECM power source circuit (Click here ).



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ECM (Click here)


← ECM Communication Stop Mode (May 2007 – Jul 2008)ECM Communication Stop Mode (from Jul 2010) →