INSPECTION
Inspection · Vehicles built from May 2007
| INSPECT ENGINE SWITCH |
![]() ![]() |
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Switch Condition
Specified Condition
7 (SS1) - 5 (GND)
Not pushed
10 kΩ or higher
2 (SS2) - 5 (GND)
Not pushed
10 kΩ or higher
7 (SS1) - 5 (GND)
Pushed
15 Ω
2 (SS2) - 5 (GND)
Pushed
15 Ω
Apply battery voltage between the terminals of the switch, and check the illumination condition of the switch.
- HINT:
- If the positive (+) lead and the negative (-) lead are incorrectly connected, the engine switch indicator light will not illuminate.
- If the voltage is too low, the indicator light will not illuminate.
- If the positive (+) lead and the negative (-) lead are incorrectly connected, the engine switch indicator light will not illuminate.
- OK:
Measurement Condition
Specified Condition
Battery positive (+) → Terminal 11 (SWIL)
Battery negative (-) → Terminal 4 (COM) or 5 (GND)
Illuminates
Battery positive (+) → Terminal 12 (INDS)
Battery negative (-) → Terminal 4 (COM) or 5 (GND)
Illuminates
Battery positive (+) → Terminal 13 (INDW)
Battery negative (-) → Terminal 4 (COM) or 5 (GND)
Illuminates


If the result is not as specified, replace the engine switch.

