2007-2013 Highlander Kluger · Service Manual BODY

ON-VEHICLE INSPECTION

Inspection · Vehicles built from May 2007


INSPECT REAR DOOR PANEL SUB-ASSEMBLY

  1. Check that the clearance measurements of areas A through K are within each standard range.

    B172918E01

    Standard clearance:
    Area
    Measurement
    Area
    Measurement
    A
    3.3 to 6.3 mm (0.130 to 0.248 in.)
    G
    3.0 to 6.0 mm (0.118 to 0.236 in.)
    B
    -1.5 to 1.5 mm (-0.059 to 0.059 in.)
    H
    4.2 to 7.2 mm (0.165 to 0.284 in.)
    C
    3.3 to 6.3 mm (0.130 to 0.248 in.)
    I
    3.1 to 6.1 mm (0.122 to 0.240 in.)
    D
    -1.5 to 1.5 mm (-0.059 to 0.059 in.)
    J
    4.0 to 8.0 mm (0.158 to 0.315 in.)
    E
    3.3 to 6.3 mm (0.130 to 0.248 in.)
    K
    6.3 to 10.3 mm (0.248 to 0.405 in.)
    F
    4.2 to 7.2 mm (0.165 to 0.284 in.)
    -
    -

← COMPONENTS (from Jul 2010)DISASSEMBLY (May 2007 – Jul 2008) →