B2284 Brake Signal Malfunction
Diagnostic trouble codes · Vehicles built Jul 2010 – Jun 2012
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 Jul 2010 – Jun 2012 from Jul 2012
DESCRIPTION
- HINT:
- If the main body ECU is replaced with a new one while the negative (-) battery terminal is connected, the power source mode will be in IG-ON mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.
- After the main body ECU is replaced, perform the registration procedure for the engine immobiliser system.
| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2284 |
The brake signal circuit between the main body ECU and the stop light switch is malfunctioning and the CAN information is inconsistent |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| EMERGENCY ENGINE START CONTROL |
If there is a malfunction in the stop light switch circuit or STOP fuse, their signals may not be correctly transmitted to the main body ECU. This may result in the engine not starting even if the engine switch is pressed while the brake pedal is depressed and the shift lever is in the P position.
To activate the starter:Turn the engine switch from off to on (ACC).
Press and hold the engine switch for 15 seconds.
| 1. CHECK DTC OUTPUT (CAN COMMUNICATION SYSTEM) |
Delete the DTCs (Click here).
Check for CAN communication system DTCs (Click here).
- HINT:
- If the DTCs for the CAN communication system malfunction are output, inspect those DTCs first (Click here).
- OK:
- DTCs for CAN communication system are not output.
|
|
||||
| OK | |
| 2. CHECK DTC OUTPUT |
Delete the DTCs (Click here).
Check for DTCs again.
Proceed to the next step based on the inspection result.
- Result:
Result
Proceed to
No DTC is output
A
Engine control system DTCs are output
B
Vehicle stability control system DTCs are output
C
|
|
||||
|
|
||||
| A | |
| 3. READ VALUE USING INTELLIGENT TESTER (STOP LIGHT SWITCH) |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Check the DATA LIST for proper functioning of the stop light switch.
Body: Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Stop Light SW
Stop light switch/ON or OFF
ON: Brake pedal depressed
OFF: Brake pedal released
-
- OK:
- ON (brake pedal depressed) and OFF (brake pedal released) appear on the screen.
|
|
||||
| OK | ||
| ||
| 4. CHECK OPERATION OF STOP LIGHT |
Check whether the stop lights turn on and off normally when the brake pedal is depressed and released.
- OK:
- Stop lights turn on when brake pedal is depressed.
|
|
||||
| OK | ||
| ||
| 5. CHECK HARNESS AND CONNECTOR (STOP LIGHT CONTROL RELAY - INSTRUMENT PANEL JUNCTION BLOCK) |
Disconnect the 1C connector from the instrument panel junction block.
Remove the stop light control relay from the engine room relay block.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
1C-13 - Engine room relay block stop light control relay terminal 3
Always
Below 1 Ω
1C-13 - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
