2007-2013 Highlander Kluger · Service Manual RESTRAINTS

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

HINT:
*: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.CUSTOMER PROBLEM ANALYSIS
    1. Confirm problem symptoms (Click here).

    NEXT

    3.CHECK CAN COMMUNICATION SYSTEM*
    1. Use the intelligent tester to check if the CAN communication system is functioning normally.

      HINT:
      Refer to the "Bus Check" for the CAN communication system (Click here).
      The center airbag sensor assembly is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN communication system.

      Result:
      Result
      Proceed to
      CAN communication DTC is not output.
      A
      CAN communication DTC is output.
      B


    B.
    A

    4.SRS WARNING LIGHT CHECK
    1. Proceed to Diagnosis System (Click here).

    NEXT

    5.CHECK FOR DTC*
    1. Proceed to DTC Check / Clear (Click here).

      Result:
      Result
      Proceed to
      DTC is output.
      A
      DTC is not output.
      B


    B.
    A

    6.DIAGNOSTIC TROUBLE CODE CHART
    1. Proceed to Diagnostic Trouble Code Chart (Click here).

    NEXT

    7.SYMPTOM SIMULATION
    1. Proceed to Diagnosis System (Click here).

    NEXT

    8.PROBLEM SYMPTOMS TABLE
    1. Proceed to Problem Symptoms Table (Click here).

    NEXT

    9.CIRCUIT INSPECTION*
      NEXT

      10.IDENTIFICATION OF PROBLEM
        NEXT

        11.REPAIR OR REPLACEMENT
          NEXT

          12.CONFIRMATION TEST
            NEXT

            ← HOW TO PROCEED WITH TROUBLESHOOTING (May 2007 – Jul 2008)HOW TO PROCEED WITH TROUBLESHOOTING (from Jul 2010) →