2007-2013 Highlander Kluger · Service Manual RESTRAINTS

DATA LIST / ACTIVE TEST

System information · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jun 2010 from Jul 2010

HINT:
Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values when deciding whether a part is faulty or not.


DATA LIST FOR CENTER AIRBAG SENSOR ASSEMBLY
  1. Turn the ignition switch off.

  2. Connect the intelligent tester to the DLC3.

  3. Turn the ignition switch on (IG).

  4. Turn the tester on.

  5. Enter the following menus: Body / SRS Airbag / Data List.

  6. Check the values by referring to the table below.

    SRS Airbag 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Driver Seat Position
    Driver Seat Position/
    Forward: Seat position is forward
    Bkward: Seat position is backward
    Forward/Bkward
    -
    Left Side Buckle SW
    Left Side Buckle SW/
    Unset: The seat belt is not fastened
    Set: The seat belt is fastened
    NG: Data is not determined
    Unset/Set
    -
    Right Side Buckle SW
    Right Side Buckle SW/
    Unset: The seat belt is not fastened
    Set: The seat belt is fastened
    NG: Data is not determined
    Unset/Set
    -
    Display Type Information
    Display Type Information/
    LR: The display is indicated by LH/RH
    DP: The display is indicated by Driver/Passenger
    LR
    -
    Number or Past DTC
    Number of Past DTC/
    Min.: 0, Max.: 255
    0
    -

← DATA LIST / ACTIVE TEST (May 2007 – Jun 2010)DIAGNOSTIC TROUBLE CODE CHART (May 2007 – Jul 2008) →