CHECK FOR INTERMITTENT PROBLEMS
Troubleshooting · Vehicles built May 2007 – Jul 2008
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
| CHECK FOR INTERMITTENT PROBLEMS |
- HINT:
- A momentary interruption (open circuit) in the connectors and/or wire harnesses between the sensors and ECUs can be detected using the ECU Data List function of the intelligent tester.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Turn the intelligent tester on.
Follow the directions on the intelligent tester to display the Data List and select areas where momentary interruptions should be monitored.

- HINT:
- A momentary interruption (open circuit) cannot be detected for 3 seconds after the ignition switch is turned on (IG) (initial check).
- If the ERROR display remains displayed, check for continuity between the ECUs and the sensors, or between ECUs.
- The ERROR display on the intelligent tester will remain displayed for 1 second after the harness signal changes from momentary interruption (open circuit) to normal condition.
- A momentary interruption (open circuit) cannot be detected for 3 seconds after the ignition switch is turned on (IG) (initial check).
ABS / VSC / TRC: Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
FR Speed Open
FR speed sensor open detection / ERROR or NORMAL
ERROR: Momentary interruption
NORMAL: Normal
-
FL Speed Open
FL speed sensor open detection / ERROR or NORMAL
ERROR: Momentary interruption
NORMAL: Normal
-
RR Speed Open
RR speed sensor open detection / ERROR or NORMAL
ERROR: Momentary interruption
NORMAL: Normal
-
RL Speed Open
RL speed sensor open detection / ERROR or NORMAL
ERROR: Momentary interruption
NORMAL: Normal
-
EFI Communication Open
EFI communication open detection / ERROR or NORMAL
ERROR: Momentary interruption
NORMAL: Normal
-
Yaw Rate Open
Yaw rate sensor open detection / ERROR or NORMAL
ERROR: Momentary interruption
NORMAL: Normal
-
Deceleration Open
Acceleration sensor open detection / ERROR or NORMAL
ERROR: Momentary interruption
NORMAL: Normal
-
Steering Open
Steering angle sensor open detection / ERROR or NORMAL
ERROR: Momentary interruption
NORMAL: Normal
-
Master Cylinder Open
Master cylinder pressure sensor open detection / ERROR or NORMAL
ERROR: Momentary interruption
NORMAL: Normal
-
While observing the screen, gently jiggle the connectors or wire harnesses between the ECUs and sensors, or between ECUs.

- OK:
- NORMAL display appears.
- HINT:
- The connector and/or wire harness has a momentary interruption (open circuit) if the display changes. Repair or replace the connectors and/or wire harnesses as one of them is faulty.