C1421 Open or Short in Master Cylinder Pressure Sensor
Diagnostic trouble codes · Vehicles built Aug 2008 – Jun 2010
Also covers:
- C1423 Master Cylinder Pressure Sensor Zero Point Low Malfunction
- C1424 Master Cylinder Pressure Sensor Output Malfunction
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
DESCRIPTION
The master cylinder pressure sensor is connected to the skid control ECU in the brake actuator assembly.

| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1421 |
Either of the following is detected:
|
Brake actuator assembly (Master cylinder pressure sensor) |
| C1423 |
The PMC terminal voltage is less than 0.27 V for 5 seconds or more. |
Brake actuator assembly (Master cylinder pressure sensor) |
| C1424 |
Any of the following is detected:
|
Brake actuator assembly (Master cylinder pressure sensor) |
WIRING DIAGRAM
Refer to DTC C1425 (Click here).INSPECTION PROCEDURE
- NOTICE:
- When replacing the brake actuator assembly, perform zero point calibration (Click here).
| 1. REPLACE BRAKE ACTUATOR ASSEMBLY |
Replace the brake actuator assembly (master cylinder pressure sensor) (Click here).
| NEXT | ||
| ||
