2007-2013 Highlander Kluger · Service Manual BRAKE

C1433 Steering Angle Sensor Internal Circuit

Diagnostic trouble codes · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

Steering angle sensor signals are sent to the skid control ECU via the CAN communication system. When there is a malfunction in the CAN communication system, it will be detected by the steering angle sensor zero point malfunction diagnostic function.
DTC Code
DTC Detection Condition
Trouble Area
C1433
Either of the following is detected:
  1. With the IG1 terminal voltage 9.5 to 17.4 V, the skid control ECU receives an error signal from the steering angle sensor for 0.012 seconds.
  2. An open in the sensor power supply circuit for 1 second or more.
Steering angle sensor

WIRING DIAGRAM

Refer to DTC C1432 (Click here).

INSPECTION PROCEDURE

HINT:
  1. When U0073, U0123, U0124 and/or U0126 is output together with C1433, inspect and repair the trouble areas indicated by U0073, U0123, U0124 and/or U0126 first (Click here).
  2. When any of the speed sensors or the yaw rate and acceleration sensor has trouble, DTCs for the steering angle sensor may be output even when the steering angle sensor is normal. When DTCs for the speed sensors or yaw rate and acceleration sensor are output together with DTCs for the steering angle sensor, inspect and repair the speed sensor and yaw rate and acceleration sensor first, and then inspect and repair the steering angle sensor.


1. REPLACE STEERING ANGLE SENSOR
  1. Replace the steering angle sensor (Click here).

    HINT:
    If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step (Click here).


NEXT

END


← C1433 Steering Angle Sensor Internal Circuit (Aug 2008 – Jun 2010)C1434 Steering Angle Sensor Output Malfunction (May 2007 – Jul 2008) →