PRECAUTION
Precautions · Vehicles built May 2007 – Jul 2008
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
| 1.PRECAUTION FOR DISCONNECTING THE BATTERY CABLE |
- NOTICE:
- When disconnecting the battery negative (-) terminal, initialize the following systems after the terminal is reconnected:
| System |
See Procedure |
| Parking Assist Monitor System |
Click here
|
| Power Back Door System |
Click here
|
| 2.PRECAUTIONS WHEN WORKING ON STEERING LOCK SYSTEM |
After replacing the steering lock actuator assembly (steering lock ECU), perform the key ID code registration.
If the steering lock actuator assembly is replaced, open and close the driver's door. The engine may not start until the driver's door is opened or closed.
- HINT:
- Opening and closing the driver's door causes the steering lock actuator assembly (steering lock ECU) to memorize the correct steering lock bar position.
If checking for DTCs of the smart entry and start system or if checking the DATA LIST with the engine switch off, make sure that the driver's door is open.
- HINT:
- When the engine switch is off, the main body ECU may be in sleep mode. If the main body ECU is in this sleep mode, it will not be possible for the intelligent tester to communicate with it. Opening and closing the driver's door will cause the ECU to exit sleep mode.
| 3.PRECAUTIONS FOR STEERING LOCK ACTUATOR |
- NOTICE:
- If the steering lock actuator assembly (steering lock ECU) is replaced, with the engine switch off and the shift lever in the N position, open and close the driver's door to record the current steering lock position into the steering lock ECU. If this is not performed, the engine may not start.