2007-2013 Highlander Kluger · Service Manual BODY

DTC CHECK / CLEAR

Troubleshooting · Vehicles built from May 2007


CHECK DTC
  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch on (IG).

  3. Check the DTC(s).


CLEAR DTC
  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch on (IG).

  3. Clear the DTCs.

  4. Check that "DTCs are cleared" is displayed.

    NOTICE:
    If any DTCs are output, troubleshoot those DTCs again.

← DIAGNOSIS SYSTEM (from May 2007)FAIL-SAFE CHART (from May 2007) →