2007-2013 Highlander Kluger · Service Manual RESTRAINTS

B1000/31 Center Airbag Sensor Assembly Malfunction

Diagnostic trouble codes · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

The center airbag sensor assembly consists of the deceleration sensor, the safing sensor, the drive circuit, the diagnosis circuit, the ignition control, etc.
If the center airbag sensor assembly receives signals from the deceleration sensor, it determines whether the airbag squib and pretensioner squib should be activated.
DTC B1000/31 is recorded when a malfunction is detected in the center airbag sensor assembly.
DTC No.
DTC Detection Condition
Trouble Area
B1000/31
Center airbag sensor assembly malfunction
Center airbag sensor assembly

INSPECTION PROCEDURE

HINT:
When a trouble code is displayed simultaneously with B1000/31, repair the malfunction indicated by this code (except B1000/31) first.


1. CHECK CENTER AIRBAG SENSOR ASSEMBLY

  1. C157589E01
    Turn the ignition switch on (IG), and wait for at least 60 seconds.

  1. Clear the DTCs stored in the memory (Click here).

  1. Turn the ignition switch off.

  1. Turn the ignition switch on (IG), and wait for at least 60 seconds.

  1. Check the DTCs (Click here).

    OK:
    DTC B1000/31 is not output.



NG
REPLACE CENTER AIRBAG SENSOR ASSEMBLY (Click here)
OK

USE SIMULATION METHOD TO CHECK (Click here)


← B1000/31 Center Airbag Sensor Assembly Malfunction (Aug 2008 – Jun 2010)B1603/83 Front Satellite Sensor Bus RH Initialization Incomplete (+ B1612/83, B1613/83) (May 2007 – Jul 2008) →