INSTALLATION
Removal / installation · Vehicles built Aug 2008 – Jun 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
| 1.
INSTALL TRANSMISSION VALVE BODY ASSEMBLY
|
 |
- Install the spring and check ball body.
Align the groove of the manual valve with the pin of the lever.
- Install the 17 bolts.
-
Torque:
- 11 N*m{
110 kgf*cm
, 8 ft.*lbf
}
- NOTICE:
- Push the valve body against the accumulator piston springs and check ball body to install the valve body.
- First, temporarily tighten the bolts marked (1) in the illustration because they are positioning bolts.
- Bolt length:
- Bolt A:
- 25 mm (0.98 in.)
- Bolt B:
- 57 mm (2.24 in.)
- Bolt C:
- 41 mm (1.61 in.)
| 2.
INSTALL VALVE BODY OIL STRAINER ASSEMBLY
|
 |
- Coat a new O-ring with ATF.
Install the O-ring to the oil strainer.
- Install the oil strainer with the 3 bolts.
-
Torque:
- 11 N*m{
110 kgf*cm
, 8 ft.*lbf
}
| 3.
INSTALL TRANSMISSION WIRE
|
 |
- Coat a new O-ring with ATF.
Install the ATF temperature sensor with the lock plate and bolt.
-
Torque:
- 6.6 N*m{
67 kgf*cm
, 58 in.*lbf
}
Connect the 7 shift solenoid valve connectors.
| 4.
INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY
|
 |
- Install the 2 magnets in the oil pan.
Apply adhesive to the 18 bolts.
- Adhesive:
- Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
- Install the oil pan and a new gasket to the transaxle case with the 18 bolts.
-
Torque:
- 7.8 N*m{
80 kgf*cm
, 69 in.*lbf
}
- NOTICE:
- Apply adhesive to the bolts and tighten them within 10 minutes of application.
| 5.
INSTALL AUTOMATIC TRANSAXLE ASSEMBLY |
 |
(Click here)
| 6.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
|
 |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).