2007-2013 Highlander Kluger · Service Manual TRANSMISSION

REMOVAL

Removal / installation · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


1. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY

HINT:
Click here.


2. REMOVE AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY

  1. C091925
    Remove the 18 bolts, oil pan, and gasket.

    NOTICE:
    Some fluid will remain in the oil pan. Carefully remove the oil pan so that the fluid remaining in the pan does not spill out.

  1. D030865E03
    Remove the 2 magnets from the oil pan.

  1. AT00103
    Examine particles in the pan.

    1. Collect any steel chips using the removed magnets. Look carefully at the chips and particles in the pan and on the magnets to see the type of wear which might be found in the transaxle.

      Result:
      Steel (magnetic):
      Wear of the bearing, gear, or plate
      Brass (non-magnetic):
      Wear of the bushing


3. DISCONNECT TRANSMISSION WIRE

  1. C091927E08
    Disconnect the 7 shift solenoid valve connectors.

  1. Remove the bolt and lock plate, and disconnect the ATF temperature sensor.


4. REMOVE VALVE BODY OIL STRAINER ASSEMBLY

  1. C091931
    Remove the 3 bolts and oil strainer.

    NOTICE:
    Be careful when removing the oil strainer as fluid will come out.

  1. C091932
    Remove the O-ring from the valve body oil strainer assembly.


5. REMOVE TRANSMISSION VALVE BODY ASSEMBLY

  1. C091933
    Support the valve body assembly and remove the 17 bolts and the transmission valve body assembly.

  1. C050017
    Remove the check ball body and the spring.

← COMPONENTS (from May 2007)REMOVAL (Aug 2008 – Jun 2010) →