2007-2013 Highlander Kluger · Service Manual TRANSMISSION

REASSEMBLY

Removal / installation · Vehicles built from May 2007


1. INSTALL FRONT OIL PUMP OIL SEAL

  1. D003654E01
    Using SST and a hammer, install a new oil seal to the oil pump body.
    SST
    09350-32014   (09351-32140)

    HINT:
    The seal end should be flush with the outer edge of the oil pump.

  1. Coat the lip of the oil seal with MP grease.


2. INSTALL FRONT OIL PUMP BODY O-RING

  1. C055817E04
    Coat a new O-ring with ATF and install it to the oil pump body.

    NOTICE:
    Make sure that the O-ring is not twisted or pinched. Apply enough ATF to the O-ring before installation.


3. INSTALL FRONT OIL PUMP DRIVEN GEAR

  1. C119012E04
    Coat the front oil pump driven gear with ATF, and install it to the oil pump body with the marked side facing upward.


4. INSTALL FRONT OIL PUMP DRIVE GEAR

  1. D009206E12
    Coat the front oil pump drive gear with ATF, and install it to the oil pump body with the marked side facing upward.


5. INSTALL STATOR SHAFT ASSEMBLY

  1. D003651E01
    Set the stator shaft and align it with each bolt hole.

  1. Using a "TORX" socket (T30), install the 11 bolts.

    Torque:
    9.8 N*m{ 100 kgf*cm , 87 in.*lbf }


6. INSTALL CLUTCH DRUM OIL SEAL RING

  1. D026627E03
    Coat 2 new clutch drum oil seal rings with ATF.

  1. Install 2 new clutch drum oil seal rings.

    NOTICE:
    Do not expand the ring ends excessively.


7. INSPECT OIL PUMP ASSEMBLY

  1. D009205
    Turn the drive gear with 2 screwdrivers and make sure that it rotates smoothly.

    NOTICE:
    Be careful not to damage the oil seal lip.

← INSPECTION (from May 2007)COMPONENTS (from May 2007) →