Home › TRANSMISSION › U151E AUTOMATIC TRANSAXLE › UNDERDRIVE PLANETARY GEAR
DISASSEMBLY
Removal / installation · Vehicles built from May 2007
1.
INSPECT UNDERDRIVE PLANETARY GEAR PRELOAD
Using SST, secure the underdrive planetary gear assembly.
SST
09387-00050
Using SST and a torque wrench, measure the turning torque of the underdrive planetary gear assembly while rotating the torque wrench at 60 rpm.
SST
09387-00050
Turning torque at 60 rpm.:
0.50 to 1.42 N*m (5.1 to 14.5 kgf*cm, 4.4 to 12.6 in.*lbf)
HINT:
Use a torque wrench with a fulcrum length of 160 mm (6.3 in.).
2.
REMOVE FRONT PLANETARY GEAR NUT
Using SST, loosen the staked part of the lock nut.
SST
09930-00010
(09931-00010, 09931-00020)
09387-00050
Place the underdrive planetary gear in a soft jaw vise.
NOTICE:
Be careful not to damage the differential drive pinion.
Using a socket wrench, remove the lock nut.
3.
REMOVE CYLINDRICAL ROLLER BEARING RACE INNER
Using SST, remove the cylindrical roller bearing race inner.
SST
09950-00020 09950-00030 09950-60010
(09951-00320, 09957-04010)
4.
REMOVE UNDERDRIVE PLANETARY GEAR ASSEMBLY
Using SST and a press, remove the differential drive pinion, parking lock gear, counter driven gear with underdrive planetary ring gear, and radial ball bearing front.
SST
09950-60010
(09951-00320)
09387-00050 09950-00020 09950-00030 09950-40011
(09957-04010)
Place the underdrive planetary gear in a soft jaw vise.
Using SST, remove the radial ball bearing rear from the underdrive planetary gear.
SST
09950-60010
(09951-00320)
09950-00030 09950-40011
(09957-04010)
5.
REMOVE UNDERDRIVE PLANETARY RING GEAR
Using snap ring pliers, remove the snap ring.
Remove the underdrive planetary ring gear from the counter driven gear.