INSTALLATION
Removal / installation · Vehicles built Aug 2008 – Jun 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
| 1. INSTALL FRONT SEAT ASSEMBLY |
Place the front seat assembly in the cabin.
- NOTICE:
- Be careful not to damage the vehicle body.
Connect the connectors under the seat.
Connect the cable to the negative (-) battery terminal.
- NOTICE:
- When reconnected the cable, some systems need to be initialized (Click here).
Temporarily install the front seat assembly with the 4 bolts.
Operate the power seat switch knob and move the seat to the rearmost position.
Tighten the 2 bolts on the front side of the seat.

- Torque:
- 37 N*m{ 377 kgf*cm , 27 ft.*lbf }
- HINT:
- Tighten the bolts in the order indicated in the illustration.
Operate the power seat switch knob and move the seat to the foremost position.
Tighten the 2 bolts on the rear side of the seat.

- Torque:
- 37 N*m{ 377 kgf*cm , 27 ft.*lbf }
- HINT:
- Tighten the bolts in the order indicated in the illustration.
| 2. INSTALL REAR INNER SEAT TRACK COVER |
Engage the 2 claws and install the rear inner seat track cover.

| 3. INSTALL REAR OUTER SEAT TRACK COVER |
Engage the 2 claws and install the rear outer seat track cover.

| 4. INSTALL FRONT INNER SEAT TRACK COVER |
Operate the power seat switch knob and move the seat to the rearmost position.
Engage the 2 claws and install the front inner seat track cover.

| 5. INSTALL FRONT OUTER SEAT TRACK COVER |
Engage the 2 claws and install the front outer seat track cover.

| 6. INSTALL FRONT SEAT HEADREST ASSEMBLY |
| 7. INSPECT FRONT SEAT ASSEMBLY |
Inspect the power seat operation.
w/ Seat Heater System:
Check the seat heater operation.Turn the ignition switch on (IG).
Turn the seat heater switch on.
Wait 5 minutes or more and confirm that the seat surface becomes warm.
| 8. INSPECT SRS WARNING LIGHT |
