INSTALLATION
Removal / installation · Vehicles built Aug 2008 – Jun 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
| 1.
INSTALL FRONT POWER SEAT SWITCH |
 |
- Install the power seat switch with the 3 screws.
Connect the connector.
| 2.
INSTALL FRONT SEAT CUSHION SHIELD ASSEMBLY
|
 |
w/o Seat Cushion Front Edge Adjustment Function:
Connect the connector to the front power seat lumbar switch.
w/ Seat Cushion Front Edge Adjustment Function:
Engage the each clamps.
Connect the connector to the front power seat lumbar switch and the seat variable cushion switch.
- Engage the guide and the claw.
Install the front seat cushion shield assembly with the 5 screws.
- Engage the hooks.
| 3.
INSTALL SLIDE AND VERTICAL POWER SEAT SWITCH KNOB
|
 |
- Engage the 4 claws and install the slide and vertical power seat switch knob.
| 4.
INSTALL RECLINING POWER SEAT SWITCH KNOB
|
 |
- Engage the 2 claws and install the reclining power seat switch knob.
| 5.
INSTALL FRONT SEAT ASSEMBLY
|
 |
Place the front seat assembly in the cabin.
- NOTICE:
- Be careful not to damage the vehicle body.
Connect the connectors under the seat.
Connect the cable to the negative (-) battery terminal.
- NOTICE:
- When reconnected the cable, some systems need to be initialized (Click here).
Temporarily install the front seat assembly with the 4 bolts.
Operate the power seat switch knob and move the seat to the rearmost position.
- Tighten the 2 bolts on the front side of the seat.
-
Torque:
- 37 N*m{
377 kgf*cm
, 27 ft.*lbf
}
- HINT:
- Tighten the bolts in the order indicated in the illustration.
Operate the power seat switch knob and move the seat to the foremost position.
- Tighten the 2 bolts on the rear side of the seat.
-
Torque:
- 37 N*m{
377 kgf*cm
, 27 ft.*lbf
}
- HINT:
- Tighten the bolts in the order indicated in the illustration.
| 6.
INSTALL REAR INNER SEAT TRACK COVER
|
 |
- Engage the 2 claws and install the rear inner seat track cover.
| 7.
INSTALL REAR OUTER SEAT TRACK COVER
|
 |
- Engage the 2 claws and install the rear outer seat track cover.
| 8.
INSTALL FRONT INNER SEAT TRACK COVER
|
 |
Operate the power seat switch knob and move the seat to the rearmost position.
- Engage the 2 claws and install the front inner seat track cover.
| 9.
INSTALL FRONT OUTER SEAT TRACK COVER
|
 |
- Engage the 2 claws and install the front outer seat track cover.
| 10.
INSTALL FRONT SEAT HEADREST ASSEMBLY |
|
| 11.
INSPECT FRONT SEAT ASSEMBLY
|
 |
Inspect the power seat operation.
w/ Seat Heater System:
Check the seat heater operation.
Turn the ignition switch on (IG).
Turn the seat heater switch on.
Wait 5 minutes or more and confirm that the seat surface becomes warm.
| 12.
INSPECT SRS WARNING LIGHT |
 |
(Click here)