2007-2013 Highlander Kluger · Service Manual BODY

REMOVAL

Removal / installation · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Front Seat Side Airbag)

CAUTION:
  1. Wait for 90 seconds after disconnecting the cable to prevent airbag deployment (Click here).
  2. If the side airbag was deployed, replace the front seat assembly with a new one.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. REMOVE FRONT SEAT HEADREST ASSEMBLY

3. REMOVE FRONT OUTER SEAT TRACK COVER
  1. Lift up the seat track adjusting handle and move the seat to the rearmost position.

  1. B174583
    Disengage the 2 claws and remove the front outer seat track cover.


4. REMOVE FRONT INNER SEAT TRACK COVER

  1. B174584
    Disengage the 2 claws and remove the front inner seat track cover.


5. REMOVE REAR SEAT TRACK COVER
  1. Lift up the seat track adjusting handle and move the seat to the foremost position.

  1. B180417
    Disengage the 4 claws and remove the 2 rear seat track covers.


6. REMOVE FRONT SEAT ASSEMBLY

  1. B174587
    Remove the 2 bolts on the rear side of the seat.

  1. Lift up the seat track adjusting handle and move the seat to the rearmost position.

  1. B174588
    Remove the 2 bolts on the front side of the seat.

  1. Lift up the seat track adjusting handle and move the seat to the center position. Also, operate the reclining adjuster release handle and move the seatback to the upright position.

  1. Disconnect the connectors under the front seat assembly.

  1. Remove the front seat assembly.

    NOTICE:
    Be careful not to damage the vehicle body.

← COMPONENTS (from May 2007)REMOVAL (Aug 2008 – Jun 2010) →