2007-2013 Highlander Kluger · Service Manual SECURITIES

ECU Power Source Circuit

Circuit diagnosis · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

This circuit provides power for main body ECU operation.

WIRING DIAGRAM

B177823E03

INSPECTION PROCEDURE


1. CHECK INSTRUMENT PANEL JUNCTION BLOCK (MAIN BODY ECU (POWER SOURCE))

  1. B177819E03
    Disconnect the 1D junction block connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Specified Condition
    1D-16 - Body ground
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. CHECK HARNESS AND CONNECTOR (INSTRUMENT PANEL JUNCTION BLOCK - BODY GROUND)

  1. B177820E03
    Disconnect the 1F and 1M junction block connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    1F-10 - Body ground
    Below 1 Ω
    1M-9 - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Security Indicator Light Circuit (from Jul 2010)ECU Power Source Circuit (Aug 2008 – Jun 2010) →