2007-2013 Highlander Kluger · Service Manual SUSPENSION & AXLE

REMOVAL

Removal / installation · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE

HINT:
Remove engine assembly with transaxle (Click here).


2. REMOVE NO. 1 FRONT STABILIZER BRACKET LH

  1. C167140
    Remove the 2 bolts and the No. 1 front stabilizer bracket LH from the front frame assembly.


3. REMOVE NO. 1 FRONT STABILIZER BRACKET RH

HINT:
Perform the same procedure as the LH side.


4. REMOVE FRONT STABILIZER BAR WITH FRONT STABILIZER LINK ASSEMBLY

5. REMOVE POWER STEERING LINK ASSEMBLY

  1. C166343
    Remove the 2 bolts, 2 nuts, and power steering link assembly.

    NOTICE:
    Because the nut has its own stopper, do not turn the nut. Loosen the bolt with the nut fixed.


6. INSTALL ENGINE HANGERS

  1. A129635E01
    Install the 2 engine hangers with the 4 bolts as shown in the illustration.

    Part No.:
    No. 1 engine hanger 12281-31120
    No. 2 engine hanger 12282-31100
    Bolts 91671-10825

    Torque:
    33 N*m{ 337 kgf*cm , 24 ft.*lbf }

  1. Attach the engine sling device and hang the engine with the chain block.


7. SEPARATE FRONT FRAME ASSEMBLY

  1. A310339
    Disconnect the active mount VSV connector and harness clamp.

  1. Loosen the bolt and 2 nuts.

    A310338E01

  1. Remove the 5 hole plugs.

    A172972E01

  1. Remove the 9 nuts.

    A172973E01

  1. A171830
    Remove the 2 bolts and separate the engine with transaxle from the front frame assembly.


8. REMOVE FRONT LOWER SUSPENSION ARM

  1. C167143
    Remove the 3 bolts, nut, and the front lower suspension arm from the front frame assembly.

  1. Remove the front lower arm bushing stopper from the front lower suspension arm.

← REMOVAL (Aug 2008 – Jun 2010)INSTALLATION (May 2007 – Jul 2008) →