2007-2013 Highlander Kluger · Service Manual SUSPENSION & AXLE

INSTALLATION

Removal / installation · Vehicles built from May 2007


1. INSTALL REAR STABILIZER BUSHING (for LH Side)

  1. C167802
    Install the rear stabilizer bushing.


2. INSTALL REAR STABILIZER BUSHING (for RH Side)

HINT:
Perform the same procedure as the LH side.


3. INSTALL REAR NO. 1 STABILIZER BAR BRACKET (for LH Side)

  1. C167800
    Install the rear stabilizer bar bracket.


4. INSTALL REAR NO. 1 STABILIZER BAR BRACKET (for RH Side)

HINT:
Perform the same procedure as the LH side.


5. INSTALL REAR STABILIZER BAR

  1. C170677E01
    Install the rear stabilizer bar with the 4 bolts.

    Torque:
    19 N*m{ 194 kgf*cm , 14 ft.*lbf }


6. INSTALL REAR STABILIZER LINK ASSEMBLY LH

  1. C167798E02
    Install the rear stabilizer link assembly LH to the rear shock absorber with coil spring LH with the nut.

    Torque:
    39 N*m{ 400 kgf*cm , 29 ft.*lbf }

    HINT:
    If the ball joint turns together with the nut, use a hexagon wrench (5 mm) to hold the stud bolt.

  1. C167797E02
    Install the rear stabilizer link assembly LH to the rear stabilizer bar with the nut.

    Torque:
    39 N*m{ 400 kgf*cm , 29 ft.*lbf }

    HINT:
    If the ball joint turns together with the nut, use a hexagon wrench (5 mm) to hold the stud bolt.


7. INSTALL REAR STABILIZER LINK ASSEMBLY RH

HINT:
Perform the same procedure as the LH side.


8. INSTALL REAR WHEELS

Torque:
103 N*m{ 1050 kgf*cm , 76 ft.*lbf }

← INSPECTION (from May 2007)COMPONENTS (from May 2007) →