2007-2013 Highlander Kluger · Service Manual SUSPENSION & AXLE

REMOVAL

Removal / installation · Vehicles built from May 2007


1. REMOVE REAR WHEELS

2. REMOVE REAR STABILIZER LINK ASSEMBLY LH

  1. C167797E01
    Remove the nut and separate the rear stabilizer link assembly LH from the rear stabilizer bar.

    HINT:
    If the ball joint turns together with the nut, use a hexagon wrench (5 mm) to hold the stud bolt.

  1. C167798E01
    Remove the nut and the rear stabilizer link assembly LH from the rear shock absorber with coil spring LH.

    HINT:
    If the ball joint turns together with the nut, use a hexagon wrench (5 mm) to hold the stud bolt.


3. REMOVE REAR STABILIZER LINK ASSEMBLY RH

HINT:
Perform the same procedure as the LH side.


4. REMOVE REAR STABILIZER BAR

  1. C170677E01
    Remove the 4 bolts and rear stabilizer bar.


5. REMOVE REAR NO. 1 STABILIZER BAR BRACKET (for LH Side)

  1. C167800
    Remove the rear No. 1 stabilizer bar bracket.


6. REMOVE REAR NO. 1 STABILIZER BAR BRACKET (for RH Side)

HINT:
Perform the same procedure as the LH side.


7. REMOVE REAR STABILIZER BUSHING (for LH Side)

  1. C167801
    Remove the rear stabilizer bushing.


8. REMOVE REAR STABILIZER BUSHING (for RH Side)

HINT:
Perform the same procedure as the LH side.

← COMPONENTS (from May 2007)INSPECTION (from May 2007) →