REMOVAL
Removal / installation · Vehicles built May 2007 – Jul 2008
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
| 1.
REMOVE DECK BOARD ASSEMBLY
|
 |
- Remove the deck board assembly.
| 2.
REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY (w/ Tonneau Cover)
|
 |
- Disengage the 2 guides and remove the No. 3 deck board sub-assembly.
| 3.
REMOVE NO. 2 DECK BOARD SUB-ASSEMBLY (w/ Tonneau Cover)
|
 |
- Disengage the 2 guides and remove the No. 2 deck board sub-assembly.
| 4.
REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
|
 |
Remove the tonneau cover assembly.
| 5.
REMOVE REAR MAT
|
 |
- Remove the rear mat.
| 6.
REMOVE DECK TRIM SERVICE HOLE COVER |
|
| 7.
REMOVE LOWER SPARE WHEEL CARRIER HINGE COVER |
|
| 9.
REMOVE SPARE WHEEL CARRIER LOCK COVER |
|
| 11.
REMOVE TAIL EXHAUST PIPE ASSEMBLY
|
 |
- Remove the 2 bolts and 2 compression springs.
Disconnect the exhaust pipe support and remove the tail exhaust pipe assembly.
Remove the gasket from the center exhaust pipe assembly.
| 12.
REMOVE REAR STABILIZER LINK ASSEMBLY LH |
 |
- Remove the nut and separate the rear stabilizer link assembly LH from the rear stabilizer bar.
- HINT:
- If the ball joint turns together with the nut, use a hexagon wrench (5 mm) to hold the stud bolt.
- Remove the nut and the rear stabilizer link assembly LH from the rear shock absorber with coil spring LH.
- HINT:
- If the ball joint turns together with the nut, use a hexagon wrench (5 mm) to hold the stud bolt.
| 13.
REMOVE REAR STABILIZER LINK ASSEMBLY RH |
 |
- HINT:
- Perform the same procedure as the LH side.
| 14.
REMOVE REAR STABILIZER BAR BRACKET LH (for Rear Side) |
 |
- Remove the 2 bolts and the rear stabilizer bar bracket LH (rear side).
| 15.
REMOVE REAR STABILIZER BAR BRACKET RH (for Rear Side) |
 |
- Remove the 2 bolts and the rear stabilizer bar bracket RH (rear side).
| 16.
REMOVE REAR STABILIZER BUSHING (for LH Side) |
 |
- Remove the rear stabilizer bushing (LH side).
| 17.
REMOVE REAR STABILIZER BUSHING (for RH Side) |
 |
- Remove the rear stabilizer bushing (RH side).
| 18.
REMOVE REAR STABILIZER BAR BRACKET LH (for Front Side) |
 |
- Remove the bolt and the rear stabilizer bar bracket LH (front side).
| 19.
REMOVE REAR STABILIZER BAR BRACKET RH (for Front Side) |
 |
- Remove the 2 bolts and the rear stabilizer bar bracket RH (front side).
| 20.
REMOVE REAR STABILIZER BAR |
|