2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

Parking Brake Switch Circuit

Circuit diagnosis · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

This circuit is from the parking brake switch to the navigation receiver assembly.

WIRING DIAGRAM

E150784E02

INSPECTION PROCEDURE


1. CHECK BRAKE WARNING LIGHT
  1. Check that the brake warning light comes on when the parking brake is applied and goes off when it is released.

    OK:
    The brake warning light operates as specified above.



NG
Go to step 3
OK


2. CHECK HARNESS AND CONNECTOR (PARKING BRAKE SWITCH - NAVIGATION RECEIVER)

  1. E141022E08
    Disconnect navigation receiver assembly connector E4 and parking brake switch connector A18.

  1. E150785E04
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester connection
    Condition
    Specified condition
    E4-1 (PKB) - A18-1
    Always
    Below 1 Ω
    E4-1 (PKB) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

3. INSPECT PARKING BRAKE SWITCH

  1. E071372E01
    Disconnect the parking brake switch.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester connection
    Condition
    Specified condition
    Switch connector - Switch body
    ON (When shaft is not pressed)
    Below 1 Ω
    Switch connector - Switch body
    OFF (When shaft is pressed)
    10 kΩ or higher



NG
REPLACE PARKING BRAKE SWITCH (Click here)
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR


← Parking Brake Switch Circuit (May 2007 – Jul 2008)Parking Brake Switch Circuit (from Jul 2010) →