2007-2013 Highlander Kluger · Service Manual BODY

INSPECTION

Inspection · Vehicles built from May 2007


INSPECT SEAT HEATER SWITCH

  1. B176313E02
    Inspect the driver side seat heater switch operation.

    1. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Switch Position
      Specified Condition
      3 (IG) - 5 (SW)
      OFF
      10 kΩ or higher
      3 (IG) - 5 (SW)
      ON
      Below 1 Ω
      4 (RV) - 5 (SW)
      ON (Minimum to Maximum)
      0.35 to 3.4 kΩ

      If the result is not as specified, replace the switch.

    2. Turn the seat heater switch on and check if the seat heater switch indicator comes on.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 3 (IG)
      Battery negative (-) → Terminal 9 (E)
      Comes on

      If the result is not as specified, replace the switch.

  1. B176314E02
    Inspect the front passenger side seat heater switch operation.

    1. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Switch Position
      Specified Condition
      3 (IG) - 8 (SW)
      OFF
      10 kΩ or higher
      3 (IG) - 8 (SW)
      ON
      Below 1 Ω
      2 (RV) - 8 (SW)
      ON (Minimum to Maximum)
      0.35 to 3.4 kΩ

      If the result is not as specified, replace the switch.

    2. Turn the seat heater switch on and check if the seat heater switch indicator comes on.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 3 (IG)
      Battery negative (-) → Terminal 9 (E)
      Comes on

      If the result is not as specified, replace the switch.

  1. Check if the seat heater switch indicator comes on.

    B176315E02

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 10 (ILL+)
    Battery negative (-) → Terminal 6 (ILL-)
    Comes on

    If the result is not as specified, replace the switch.

← REMOVAL (from Jul 2010)INSTALLATION (May 2007 – Jul 2008) →