IG Signal Circuit
Circuit diagnosis · Vehicles built from Jul 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
DESCRIPTION
- The main body ECU receives IG signal to control the following systems:
- Automatic light control system
- Light auto turn-off system
- Illuminated entry system
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Turn the intelligent tester on.
Select the following menu items: Body Electrical / Main Body / Data List.
Read the display on the intelligent tester.
Main Body: Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
IG SW
Ignition switch or engine switch IG signal / ON or OFF
ON: Ignition switch on (IG)
OFF: Ignition switch off
-
- OK:
- Normal conditions listed above are displayed.
|
|
||||
| OK | ||
| ||
| 2. INSPECT FUSE (ECU-IG NO. 1) |
Remove the ECU-IG No. 1 fuse from the instrument panel junction block.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
ECU-IG No. 1 fuse
Always
Below 1 Ω
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (IG POWER SOURCE CIRCUIT) |
Measure the voltage between the loading slot of the fuse and body ground.

- Standard voltage:
Tester Connection
Switch Condition
Specified Condition
ECU-IG No. 1 fuse terminal - Body ground
Ignition switch off
Below 1 V
Ignition switch on (IG)
11 to 14 V
|
|
||||
| OK | ||
| ||
