Front Fog Light Circuit
Circuit diagnosis · Vehicles built May 2007 – Jul 2008
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 Jul 2010 – Jun 2012 from Jul 2012
DESCRIPTION
The main body ECU controls the front fog light relay when a signal is received from the headlight dimmer switch assembly.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Turn the intelligent tester on.
Select the following menu items: Body Electrical / Main Body / Active Test.
Check that the relay operates.
Main Body: Tester Display
Test Part
Control Range
Diagnostic Note
Front Fog Light Relay
Front fog light relay
ON/OFF
-
- OK:
- Front fog light relay operates. (Front fog lights come on.)
|
|
||||
| OK | ||
| ||
| 2. INSPECT FUSE (FR FOG) |
Remove the FR FOG fuse from the instrument panel junction block.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
FR FOG fuse
Always
Below 1 Ω
|
|
||||
| OK | |
| 3. INSPECT FOG LIGHT RELAY (FOG) |
Remove the front fog light relay from the instrument panel junction block.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
3 - 5
Voltage is not applied between terminals 1 and 2
10 kΩ or higher
3 - 5
Apply the battery voltage between terminals 1 and 2
Below 1 Ω
|
|
||||
| OK | |
| 4. CHECK HARNESS AND CONNECTOR (BATTERY - FRONT FOG LIGHT RELAY) |
Measure the voltage according to the value(s) in the table below.

- Standard voltage:
Tester Connection
Condition
Specified Condition
Front fog light relay terminal 5 - Body ground
Always
11 to 14 V
Front fog light relay terminal 1 - Body ground
Light control switch OFF → TAIL
Below 1 V → 11 to 14 V
|
|
||||
| OK | |
| 5. CHECK HARNESS AND CONNECTOR (FRONT FOG LIGHT RELAY - MAIN BODY ECU) |
Disconnect the D7 main body ECU connector.


Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
Front fog light relay terminal 2 - D7-4 (FFGO)
Always
Below 1 Ω
D7-4 (FFGO) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 6. INSPECT MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK) |
Reconnect the D7 main body ECU connector.


Install the front fog light relay to the instrument panel junction block.
Measure the voltage according to the value(s) in the table below.
- Standard voltage:
Tester Connection
Switch Condition
Specified Condition
D7-4 (FFGO) - Body ground
Light control switch in HEAD, front fog light switch OFF → ON
11 to 14 V → Below 1 V
|
|
||||
| OK | ||
| ||
